Table of Contents
Advertisement
ENGLISH
Parts and functions
Front panel
Operation indicator lamp
Off:
No disc inside
Steady Green: Disc inserted in the drive
Steady Orange: Recording, playback or tray
opening/closing
Flashing Green: Error
(See page 136.)
Manual eject hole
Used to manually eject the tray in the event it
doesn't eject normally using the open/close
button or software commands.
Use this procedure as a last resort as it
can cause malfunction.
Pulling out the tray
1. Turn off the computer.
2. Insert the emergency ejection pin (in-
cluded) 4 or 5 times.
3. Remove the emergency ejection pin.
4. Open the shutter by hand.
5. Pull the tray out horizontally.
To close the tray
1. Turn on the computer.
2. Press the open/close button.
The tray may close automatically when you
turn the computer on.
Open/close button
For opening and closing the tray.
Shutter
Mounting screw holes
Rear panel
AUDIO output connector
For connecting the internal audio cable (in-
cluded).
Jumper connector
For setting the drive's Master and Slave (See
page 30).
IDE connector
For connecting the internal IDE cable (not in-
cluded).
Power supply connector
For connecting the power cable from com-
puter.
Unassigned connector
Side panels
When securing this drive to a computer or other
device, secure the drive with the provided mount-
ing screws into the areas as indicated (either
upper or lower holes depending on your system).
You can also use the four holes on the bottom to
secure the drive.
27
Advertisement
Table of Contents
