Fastening The Buzzclip - iMerciv BuzzClip Quick Start Manual

Fastening the BuzzClip:

1. The main body and the vibrational arm always go under or between your
clothing. Only the rounded top with the sensor and the buttons should be
exposed on the outside of your clothing (i.e. on the lapel of a jacket,
between the buttons on a shirt or blouse, on the rounded neck of a T-shirt,
on the beltline, out of pockets, on the sleeves of a shirt, etc.)
2. Always ensure that the sensor is exposed outwards and is not covered by
anything so that you do not receive any false positive responses.
3. Ensure that the sensor is parallel to your body as possible. For example, if
you are wearing a buttoned up shirt, make sure that the sensor is parallel to
your chest and that it is not tilted to the left or right.
4. Ensure that you are able to operate both buttons on the BuzzClip from
where you are wearing it.
5. Ensure that the vibrational arm on the back of the device is in proper
contact with your body. You can make sure of this by pulling out so that it is
pushing up against your body. This also helps in delivering stronger
vibrations that you will feel, particularly when wearing loose clothing.
The BuzzClip can be worn many different ways based on one's mobility needs.
It can be easily clipped onto shirts, t-shirts, on sleeves (long or short),
sweaters, jeans, sweatpants, and more. Multiple BuzzClips can also be used at
once for greater coverage around one's body. This would give a blind or
partially sighted user much more information about their immediate
surroundings. For example, one on the chest and one of each sleeve in order to
protect your front and sides.