Table of Contents
Advertisement
2.3 Power on and Entering into ON Mode
Before switching on, please pay attention to the
follows:
1. Avoid temperature and motion disturbances in
front of the camera such as big leaf, curtain,
air-conditioner, air outlet of the chimney and
other heat sources to prevent from false
triggering.
2. The height from ground for placing the camera
should vary with the object size appropriately. In
general, one to two meters are preferred.
In TEST mode, it requires to connect the remote
control then to do further customizing settings,
when the user complete the settings, it requires to
unplug the control to enter into normal use, that is,
if the remote control still be connected with the
camera, the camera will not work. The camera (the
control must be unplugged when in ON mode) will
take pictures or videos automatically according to
the default settings or preset customer settings.
Slide the power switch to the ON position to power
on the camera and enter into the ON mode.
After switching on the camera, the motion
indication LED (red) will blink for about 10s. The
10s is a buffering time before autonomic capturing
photos or videos, e.g. for closing and locking the
bottom cover, mounting the camera and walking
away.
Page 6
Advertisement
Table of Contents
