Environmental Protection; Important Note Regarding Product Liability - WAGNER wallperfect W 925 E Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

WallPerfect W 925 E
Problem
Coating material
cannot be atomised

Environmental protection

The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.

Important Note regarding Product Liability!

Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
Warning
If the supply cord of this appliance is
damaged, it must only be replaced
by a repair shop appointed by the
manufacturer, because special purpose
tools are required.
Warning: Do not connect the blue
or brown wire to the earth
terminal of the plug! The
wires in this mains lead are
coloured in accordance with
the following code:
blue = neutral
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifiying the terminals in your plug, proceed as follows:
Should the moulded plug have to be replaced, never re-use the defective plug or
attempt to plug it into a different 13 A socket. This could result in an electric shock.
Should it be necessary to exchange the fuse in the plug only use fuses approved by
ASTA in accordance with BS 1362. 5 Amp fuses may be used.
To ensure that the fuse and fuse carrier are correctly mounted please observe the
provided markings or colour coding in the plug.
Cause
Multifunction switch is set to
"Clean"
Turbine is overheated
Turbine is defect
brown = live
Remedy
Set the multifunction switch
to "ON"
Unplug the power plug,
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots
Please contact Wager
Service
GB
27

Advertisement

Table of Contents
loading

Table of Contents