Table of Contents
Advertisement
MAINTENANCE
1. Remove grille. (Squeeze mounting spring and pull
down) (Fig.21-1,21-2 of page 15)
2. Remove the 4 W night lamp. (Fig.26)
3. Change the fluorescent lamps (Panasonic FDS
18E27/4, 18W or FDS18E35/4, 18W or FDS18E42/4,
18W) or the 4W night lamp, connect the plug
II
connector
and replace the grille. (Fig.27)
PRACTICAL GUIDE TO INSTALLATION
Proper insulate the area around the fan
Proper insulate the area around the fan
to minimize building heat loss and gain.
to minimize building heat loss and gain.
(Fig. 28)
(Fig. 28)
Loose fill or batt insulation can be placed
directly over the fan housing in the attic.
Panasonic fans and fan/light combination
units do not create excessive heat that is
a common problem with recessed light
fixtures or some competitors' fan/light
combinations. Our efficient, cool-running
motors and our fluorescent lamps do not
create enough ambient heat to be subjected
to these limitations.
PRODUCT SERVICE
Warning Concerning Removal of Covers.
The unit should be serviced by qualified technicians only. No service information is provided for customers.
Your product is designed and manufactured to ensure a minimum of maintenance. However, should your
unit ever require service, a nationwide system of factory service centers and AUTHORIZED INDEPENDENT
SERVICE CENTERS is maintained to support your product's warranty.
(In the U.S.A., Call 1-866-292-7292 to Customer call Center.)
PANASONIC CONSUMER ELECTRONICS COMPANY
Division of Panasonic Corporation of North America,
One Panasonic Way, Secaucus, NJ 07094
www.panasonic.com
PANASONIC CANADA INC.
5770 Ambler Drive, Mississauga, ON L4W 2T3
www.panasonic.ca
II
(REPLACEMENT OF LAMP) CONTINUED
Four inch or six inch roof jack, wall cap,
or soffit vent with backdraft damper.
2-3 ft straight run before elbow.
In attic installation,
caulk box to drywall.
Caulk termination to duct.
Short piece of flexible duct
helps alignment and absorbs
sound. Clamps plus tape at
all flex joints.
Foil tape tightly covers all metal
duct joints (glue PVC joints).
A0809-0 08VKML220
Fig.26
Fig.27
Insulation.
Fig.28
- Quick Links:
- Wiring Diagram
Hide quick links:
Advertisement
Table of Contents
