RugDoctor 93140 series User Manual page 7

HOW TO CLEAN / FEATURES (CONT)
DUAL CROSS ACTION BRUSHES (CONT
2. The DUAL CROSS ACTION BRUSHES are activated by the "SOAP &
SCRUB" button on the top of the handle. (Fig. 9)
a. The Vibrating-Oscillating Brush scrubs all sides of the carpet, deep
cleaning each fiber from the base of the carpet.
b. The Roller Brush grooms and polishes the carpet, leaving it looking
clean and finished. Note: Your Rug Doctor Deep Carpet Cleaner also
features Side Brushes for edge cleaning along carpets.
SUPER BOOST CLEANING
Not every carpet needs the same level of deep clean, some need a
SUPER BOOST. Use the "SUPER BOOST SPRAY" setting on the machine
for an extra "boost" in cleaning heavily soiled and high-traffic areas.
1. Use the SUPER BOOST SPRAY knob to select your desired level of deep
cleaning. (Fig. 10)
a. SUPER BOOST "OFF": For lightly soiled carpets set the SUPER
BOOST SPRAY on the machine to "OFF". The machine will spray
cleaning solution onto the carpet under the machine. As you pull
the machine backward, you'll see the solution dirt from the carpet
being suctioned into the machine.
b. SUPER BOOST "ON": For moderately/heavy soiled or high-traffic
carpets set the SUPER BOOST SPRAY on the machine to "ON". The
machine will spray additional cleaning solution from the "SUPER
BOOST SPRAY" nozzle.
2. Position the machine on carpet and push the POWER SWITCH down
toward the "RUG" setting.
3. Press the "SOAP & SCRUB" button on the top of the handle while
pulling the machine slowly and steadily backward in a straight line.
(Fig. 9)
4. Release the "SOAP & SCRUB" button 6 to 12 inches before ending
each pass to stop cleaning solution. Tilt the machine back and push it
forward to start a new backward cleaning pass.
EMPTYING THE WASTE WATER TANK
1. Empty the WASTE WATER TANK before the dirty water reaches the
"Full Line" (Fig. 11).
2. Turn off the machine using the POWER SWITCH.
3. Remove the WASTE WATER TANK from the machine by grasping the
tank HANDLE and lifting straight up. (Fig. 12)
4. Unscrew the WIDE OPENING LID and pour out the dirty water. (Fig. 13).
Dirty water should be poured into a toilet or outside, do not pour into
sink or tub.
5. Rinse the inside of the WASTE WATER TANK and replace the WIDE
OPENING LID, firmly tighten the lid.
6. Place the tank back on the machine by setting is straight down on the
base until it is secure. (Fig. 14)
REFILLING THE CLEAN WATER TANK
1. When the unit no longer sprays water, check the CLEAN WATER TANK
to see if it's empty.
2. If the CLEAN WATER TANK is empty, turn off the machine using the
POWER SWITCH.
rugdoctor.com 1-800-784-3628
(Fig. 9)
(Fig. 10)
(Fig. 11 )
(Fig. 12)
(Fig. 13)
(Fig. 14)
7