Alva GH310S Assembly & Operating Instructions

Indoor gas heater

Advertisement

LEAK TEST
Connection
in heater
assembly
Foamy bubbles
indicate a leak
The leak test must be carried out in a
or other sources of ignition.
1) With the cylinder connected to the
heater and the valve open, press down
the heater control knob.
the heater.
2) Brush all the connections (hose to valve,
hose to regulator, regulator into
cylinder) with a solution of equal parts
soap and water (make sure it's foamy).
3) A stream of bubbles forming indicates a
gas leak.
4) If bubbles appear, turn the cylinder
valve OFF (clockwise) and disconnect
the regulator from the gas cylinder.
5) Tighten the connection and retry the
leak test.
6) If you are unsure or if you cannot
tighten the connection, place the
cylinder outside in a cool,
well-ventilated area and contact Alva
on 086 100 ALVA (2582)
7) A leak between the regulator and
which is very dangerous and can lead to
extensive injury or even death.
FOR YOUR SAFETY
IF YOU SMELL GAS:
• TURN OFF GAS SUPPLY AT CYLINDER
• EXTINGUISH ALL NAKED FLAMES.
DO NOT OPERATE ANY ELECTRICAL
APPLIANCES.
• VENTILATE THE AREA
• CHECK FOR LEAKS AS DETAILED
IN THIS MANUAL
• IF ODOUR PERSISTS, CONTACT YOUR
DEALER OR GAS SUPPLIER IMMEDIATELY .
PRECAUTIONS
• LEAK TEST ALL CONNECTIONS AFTER
EACH TANK REFILL
• NEVER CHECK FOR LEAKS WITH A MATCH
OR OPEN FLAME
• DO NOT STORE OR USE GASOLINE,
OR OTHER FLAMMABLE VAPOURS
AND LIQUIDS IN THE VICINITY OF THIS
OR ANY OTHER APPLIANCE
• ANY LP GAS CYLINDER NOT CONNECTED
FOR USE MUST NOT BE STORED IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE
INDOOR GAS HEATER (GH310S)
Assembly and operating instructions
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
Distributed and serviced by ALVA Marketing ( Pty) Ltd, P.O. Box 30014, Tokai, 7966
Tel: 082 100 ALVA (2582)• E-mail: info@stingray.co.za • www.alva.co.za
@StingrayGroupSA •
www.facebook.com/AlvaGas
WARNING
THIS IS A LOW PRESSURE APPLIANCE
TO BE USED ONLY WITH A 2.8kPa
SANS 1237 APPROVED REGULATOR
(REGULATOR FITTED AND SUPPLIED)
FOR YOUR OWN SAFETY,
PLEASE READ THIS MANUAL
CAREFULLY AND ALWAYS
OPERATE THIS PRODUCT ACCORDING
TO THE INSTRUCTIONS
IT IS ILLEGAL AND DANGEROUS
TO CHANGE OR MODIFY ANY PART
OF THIS APPLIANCE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GH310S and is the answer not in the manual?

Questions and answers

Summary of Contents for Alva GH310S

  • Page 1 VICINITY OF THIS OR ANY OTHER APPLIANCE 7) A leak between the regulator and Distributed and serviced by ALVA Marketing ( Pty) Ltd, P.O. Box 30014, Tokai, 7966 Tel: 082 100 ALVA (2582)• E-mail: info@stingray.co.za • www.alva.co.za which is very dangerous and can lead to extensive injury or even death.
  • Page 2: Technical Data

    Position 3 (3 panels) 265gr/hr controls. Position 2 (2 panels) 175gr/hr • Phone the customer care line at 086 100 ALVA (2582) for assistance. Position 1 (1 panel) 90gr/hr • Heat output 4.2kW by opening a door or window in the same room.
  • Page 3: Troubleshooting

    TECHNICAL DATA Odour Combustion N/A - The combustion process will always cause an odour FEATURES DO NOT TOUCH ABOUT ALVA Strong odour Incorrect gas mixture Obtain LPG only from reputable LPG dealers Unburned gas leak Perform a leak test Always ensure there is proper...
  • Page 4: Maintenance

    The smell of raw gas (just before you ignite the appliance) from your Alva gas heater. If this product is not what you want or need, please help Alva and the environment by not damaging or destroying any part of the packaging, the manual or to allow easy gas detection.
  • Page 5: Installation

    INSTALLATION This heater makes use of an industrial • If a flash back occurs (indicated by a roaring noise), immediately close the cylinder cylinder (9kg ALVA cylinder recommended) valve. with a 5/8” BSP thread; horizontall exit valve. • Turn the heater OFF at the control knob.
  • Page 6: Using Your Heater

    If you are unsure or if you cannot tighten the not properly closed. Connections to be Leak tested connection, place the cylinder outside in a cool, Hose to valve well-ventilated area and contact Alva on Hose to regulator Regulator into cylinder 086 100 ALVA (2582). •...
  • Page 7: Exploded View Drawing

    EXPLODED VIEW DRAWING Top and side panel LPG cylinder support base Wheel F-aluminium pipe Front panel Dress guard Burner cover Flame failure and thermocouple Burner Positive off Valve Control knob Ignition button Aluminium pipe Heat insulation sheet Rear guard * Refer to Glossary on Page 1...

Table of Contents