Panasonic NV-FJ610PMP Operating Instructions Manual page 40

Playback will not operate correctly
The symptom description is indicated in
quatations " ".
"The picture is noisy or is not in color.
Horizontal bars or lines run down the screen."
' Tracking is not correct.
Adjust the tracking. See page 38.
' The TV has not been tuned to the VCR.
Tune the TV to the VCR. See page 12.
' The video heads are clogged or worn.
Consult your dealer for further advice.
Recording will not operate correctly
The symptom description is indicated in
quatations " ".
"The 1 indication flashes whenever recording
is attempted."
' The erasure prevention tab on the video
cassette has been broken off.
Use a tape with an intact erasure
prevention tab, or cover the tab hole with
adhesive tape, if the original recording is
no longer required.
"The picture is recorded with noise or a blank
screen."
' The antenna or antenna cable is
defective.
Check the antenna connection to the
VCR. See pages 9–10.
Check your normal TV picture. If there is
no picture, check your antenna.
' The VCR is not correctly tuned.
Retune the VCR. See pages 12–15.
' AV input has been selected.
Select the required TV program.
"Timer recording cannot be performed."
' The clock or calendar has been
incorrectly set.
Check the clock and calendar. Set them
to the present time. (Note that this is a
24-hour clock.) See page 18.
40
' The recording starting or ending time
setting is incorrect.
Set the recording starting and ending
time correctly.
' The VCR has not been set for timer
recording.
Press TIMER Á (TIMER REC Á) after
programming for timer recording.
"AV external recordings cannot be made."
' AV input has not been selected.
Select AV input by pressing INPUT
SELECT.
' External AV connections are incorrect.
Check that the connections for external
video and audio sources are correct.
See page 37.
' A1 cannot be selected.
DIRECT REC can be set to ON.
Set DIRECT REC to OFF. See page 23.
(NV-FJ610PMP only)
The remote controller will not operate
correctly
The symptom description is indicated in
quatations " ".
"The remote controller does not operate
correctly."
' The remote controller transmitter beam
is not reaching the VCR.
Ensure that the remote controller is
being pointed at the VCR and that the
transmitter beam is not obstructed.
' The distance is too far.
Use the remote controller within 7 m of
the VCR.
If this range is not possible, replace the
batterries.
' The batteries are exhausted.
Replace the batteries. Note the
precautions for replacement on page 8.
' The batteries are incorrectly fitted with
(+/-) reversed.
Fit the batteries correctly as shown on
page 8.