Advertisement
HOW TO USE THIS MANUAL
The main points regarding removing/installing and disassembling/assembling proce-
1
dures are shown in the exploded views.
The numbers in the exploded views indicate the required sequence of the procedure and
2
should be observed accordingly.
Symbols are used in the exploded views to indicate important aspects of the procedure.
3
A list of meanings for these symbols is provided on the following page.
It is important to refer to the job instruction charts at the same time as the exploded views.
4
These charts list the sequence that the procedures should be carried out in, as well as
providing explanations on part names, quantities, dimensions and important points relat-
ing to each relevant task.
Example:
O-ring size
In addition to tightening torques, the dimensions of the bolts and screws are also men-
5
tioned.
Example:
Bolt and screw size
In addition to the exploded views and job instruction charts, this manual provides individual
6
illustrations when further explanations are required to explain the relevant procedure.
39.5 × 2.5 mm: inside diameter (D) × ring diameter (d)
10 × 25 mm : bolt and screw diameter (D) × lenght (L)
D
d
E
Advertisement
