Table of Contents
Advertisement
AUTOPAN SETUP
GROUP
INDEX
POSITION
SPEED
DWELL TIME (sec)
Setup Steps:
① Select a desired group number (1~4 groups).
② Use the joystick on the control keyboard and select the desired preset
point (INDEX: 1~32).
③ Use the joystick on the control keyboard and change to the desired
position. If you do not wish to set all 32 preset points, set " " as the last
preset point position (POSITION: 1~33, 35~82 or ).
④ Use the joystick on the control keyboard and change to the desired
speed level (SPEED: 1~15).
⑤ Use the joystick on the control keyboard and change to the desired
retention time (DWELL TIME: 1~128 sec).
⑥ Repeat the steps 2~5 again, to setup more group preset points.
⑦ Press [CLOSE] button to exit Auto Pan Setup.
⑧ To activate a previously programmed Group Preset Function, press
[GROUP No.] + [PATTERN] button.
Tip:
1. You can select from 1-32 setting points (INDEX) and decide the pan
direction (POSITION), the pan speed (SPEED), and also the dwell time
(DWELL TIME) for each group.
2. Group number buttons in combination with PATTERN button, is used to
activate a previously programmed Group Preset Function.
3. If you do not wish to set all 32 preset points, set " " as the last preset
point.
EXAMPLE：If you wish to set only 4 preset points, you must set the 5th
Start Pattern Run
Under control mode (assume device=1), when the LCD displays:
⎡
DEVICE
⎢
⎣
group=1, then enter 1), then press PATTERN
in group number 1.
* Preset point group number may differ depending on the speed dome camera type.
Stop Pattern Run
Push Joystick to any direction.
001
001
12
10
12
preset point to " ". The system will auto pan as
follow：
(1,2,3,4) , (1,2,3,4)...
⎤
001
_ :
, enter the desired group number to be setup (Assume
⎥
⎦
Range: 1~4
Range: 1~32
Range: 80(1~33, 35~82) or
Range: 1~15 (higher the value, faster the speed)
Range: 1~128
key, to activate pattern run mode
18
Advertisement
Table of Contents
