Time Code - Panasonic AJ-D455 Menu Information

USER menu
<TIME CODE>
No.
500
501
502
503
504
505
506
507
508
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
VITC 0000
.
.
.
POS-1
0006
.
.
.
0010
VITC 0000
.
.
.
POS-2
0008
.
.
.
0010
VITC 0000
BLANK 0001
TCG 0000
REGEN 0001
0002
REGEN 0000
MODE 0001
EXT TC 0000
SEL 0001
BINARY 0000
GP 0001
0002
0003
0004
0005
0006
0007
PHASE 0000
CORR 0001
TCG CF 0000
FLAG 0001
10L This sets the position where the VITC signal is to be inserted.
.
.
.
(The same line as for VITC POS-2 in 501 cannot be
16L selected.)
.
.
.
20L
10L This sets the position where the VITC signal is to be inserted.
.
.
. (The same line as for VITC POS-1 in 500 cannot be
selected.)
18L
.
.
.
20L
This selects whether to output the VITC data to the positions
BLANK
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
THRU
0: Data is not output.
1: Data is output.
TC&UB This selects the signal to be regenerated when the time code
generator (TCG) in the REGEN mode.
TC
0: Both the time code and user bit are regenerated.
UB
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This selects whether values used in the internal time code
OFF
generator are preset from the front panel or remote controller
ON
or synchronized with time code values read from the tape.
0: Values are preset from the front panel or remote controller.
(PRESET)
1: Values are synchronized with time code values read from
the tape. (REGEN)
<Note>
When "1" is selected, values selected at set up menu No. 503
(TCG REGEN) are regenerated.
LTC This selects the time code to be used when an external time
code is to be used.
VITC
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
This sets the usage status of the user bit of the time code
000
generated by the TCG.
001
0: NOT SPECIFIED (character set not specified)
010
1: ISO CHARACTER (8 bits character set based on ISO646,
011
ISO2022)
100
2: UNASSIGNED 1 (undefined)
101
3: UNASSIGNED 2 (undefined)
110
4: UNASSIGNED 3 (undefined)
111
5: PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
This selects whether to control the phase correction of the
OFF
LTC generated by the TCG.
ON
0: Phase correction control is not performed.
1: Phase correction control is performed.
OFF This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
ON
1: CF flag is ON.
31
Description