How To Install The Nmp (Optional); How To Modify Installation For A New Device - Logic IO PNM-100 User Manual

NMP – User Guide, Version 3.00

How to install the NMP (optional)

This is a step-by-step instruction how to install the NMP application on a Windows CE
device. This is not needed if a pre-installed device has been purchased:
1) Insert SD Card with application in Windows CE device.
2) Run
Install.exe
3) Withing seconds a message box appears with the message "Installation Successful"
4) Reboot the device and the NMP is running.

How to modify installation for a new device

The installation program needs to know the location of the SD card as well as the correct
location to place the autorun program.
Before running the installation on a new device, it is therefore needed to check the folder
location etc. and to make the needed changes to the installation configuration. Once the
settings are correct, the
Open
install.xml
correct:
<EnableAutorun>
<BaseFolder>
<AutoRunFilePath>
Logic IO Aps
Holmboes Allé 14
8700 Horsens
Denmark
from the root of the SD Card.
can be used on all identical devices.
install.xml
from the root of the SD card and check that the following settings are
Set to true to have the application run automatically on startup.
Set to false to not run on startup.
Folder with the entire installation. Will normally point at the SD
card
Many WinCE devices are able to run a specific program on boot.
The location is device dependent and can not be read from the
device itself.
Contains the following two tags:
The folder that the autorun program must be placed in.
<folder>
The file name of the autorun program, e.g "Autorun.exe"
<file>
Besides the autorun program, the configuration for the autorun
program will also be placed in the folder.
Page 26 of 28
Ph: (+45) 7625 0210
Fax: (+45) 7625 0211
Email: info@logicio.com
www.logicio.com