Table of Contents
Advertisement
EWB100 Usage and Deployment Guide
16.5.18 Airbeam bootloader/minikernel version
This command specifies the latest minkernel package version. It is normally used
and the value is updated when the minikernel is (re)loaded. Note the minikernel
cannot be updated via Airbeam but must be done by CSST. The command is:
set airbeam bootloader_ver xx
16.5.19 Airbeam runtime version
This command specifies the latest runtime version. It is normally not provided by
users as the parameter is updated by the Airbeam subsystem during the
deployment process. It may be used to force the reloading of a given package
however. The command is:
set airbeam runtime_ver xx
16.5.20 Airbeam TTS version
This command specifies the latest TTS version. It is normally not provided by
users as the parameter is updated by the Airbeam subsystem during the
deployment process. It may be used to force the reloading of a given package
however. The command is:
set airbeam tts_ver xx
16.5.21 Airbeam Inactivity Timeout
This command specifies the maximum time that a Airbeam may wait for a
response from the server for any nondata transfer request. may take. If it is not
completed in this time, the process will be aborted. The command is:
set airbeam activity_timeout xx
The default is 60 seconds.
16.5.22 Airbeam Download Timeout
This command specifies the maximum time that a Airbeam download may take.
This is the actual file transfer time of the data being downloaded. If it is not
completed in this time, the process will be aborted. The command is:
set airbeam download_timeout xx
where xx is the time in seconds. The default is: 600.
16.5.23 Cradle Wait Time
When the device is inserted in the the cradle and the airbeam mode is enabled, it
will access the Airbeam FTP serer to determine is a new package needs to be
downloaded. This command specifies the delay between the insertion onto the
cradle and the actual access of the airbeam server. This delay is needed to
ensure that the battery has sufficient charge for the process. The command is:
set airbeam crdl_wait xx
Rev 1.13
Page 86
Advertisement
Table of Contents
