Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Howdens LAM2202
Summary of Contents for Howdens LAM2202
- Page 1 60cm Integrated Extractor LAM2202 User & Installation Guide...
- Page 2 European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. Page _ 2 www.howdens.com...
-
Page 3: Table Of Contents
User manual LAM2202 Index Before using the extractor Safety General Fire Saftey Safety for Children c i r y t i General information & Operation Control Panel Layout Using Your Cooker Hood General Cleaning Care and maintenance General Cleaning Grease Filters... -
Page 4: Before Using The Extractor
• Do not operate the product if the power cable is damaged. Call a Howdens’ service agent. • If the cooker hood is installed for use above a gas appliance then the provision for ventilation •... -
Page 5: Fire Saftey
User manual LAM2202 Fire Safety Do not set your cooker hood less than 700mm above your cooker. When installing the hood, ensure that the following recommended distances are observed • When installed between adjoining wall between the highest point on the hob top... -
Page 6: General Information & Operation
Cabinet Door / Facia Light Air Intake Control Panel Control Panel Layout Light Off Extraction Off 1. 2. 4. 5. Light On Extraction Level Low Motor Neon Indicator Extraction Level Medium Extraction Level High 1. 2. 4. 5. Page _ 6 www.howdens.com... -
Page 7: Using Your Cooker Hood
User manual LAM2202 Using Your Cooker Hood You should clean the appliance using a damp new cloth and warm soapy water before using the appliance for the time. You should then dry it thoroughly using a soft cloth. Make sure that it has been installed by a suitably person, as per the installation instructions. -
Page 8: Care And Maintenance
Repeat the process if required. the grease once it has dried. Close the front cover. You should wipe over the front panel with a damp cloth and hot soapy water, then dry it thoroughly with a soft cloth. Page _ 8 www.howdens.com... -
Page 9: Carbon Filters
User manual LAM2202 The Carbon Filter Replacing the Lamps If the appliance is going to be used in recirculation The extractor hood is s that may mode then it is necessary to need to be replaced periodically. This will help to absorb odours caused by cooking. -
Page 10: Installation
A charcoal • Remove the grease is to be ducted out. Remove the flexible wire retainers. • Place the carbon filter above the grease filter. • Finally replace the wire retainers and • refit the assembly. Page _ 10 www.howdens.com... -
Page 11: Before Beginging Instalation
User manual LAM2202 Before beginning installation Installing your cooker hood • Check that the product purchased is of a You will have to decide before installing your suitable size for the chosen installation area. cooker hood whether to use it in extraction mode In addition check whether there is an electrical or recirculation mode. -
Page 12: Connecting To External Ducting
If there is a gap between the rear of the cooker hood 90 degree bend. and the rear wall. There is a spacer provided that can be cut to the size of the gap and attached to the rear of the cooker hood. Page _ 12 www.howdens.com... -
Page 13: Electrical Connections
User manual LAM2202 Electrical Connections IMPORTANT: Ensure that the electricity supply is switched off before connecting. Your Extractor is intended for permanent installation. Your appliance must be connected to i r i t e l with at least 3mm contact separation. The isolation switch must be accessible after installation. (See technical data for fuse rating). - Page 14 Width (canopy): 600mm Depth (canopy): 270mm Height (canopy): 380 mm Your Cooker Hood is with: Single motor Slider control operation Slider control operation 3 Speeds Optional Extras: Charcoal HJA2914 Ducting kits: APL 2805/6/7 Grease filter: HJA2913 Page _ 14 www.howdens.com...
-
Page 15: Troubleshooting
User manual LAM2202 Troubleshooting TROUBLESHOOTING GUIDE Symptoms Possible Cause Solutions Lamp fails to operate? • A replacement lamp is probably Disconnect the mains electricity supply before necessary, but check that adjusting or replacing the lamp. the lamp is correctly into its holder. -
Page 16: Your Guarantee
What to do if you need to report a problem- Please ensure you have ready: • The product’s model & serial numbers • Howdens Proof of Purchase document • Your full contact details Call the Service Line on 0845 00 60 006 Page _ 16... - Page 17 User manual LAM2202 122.4kWh/a 65dBa Exclusive to Howdens Joinery.co Page _ 17...
- Page 20 Issue 6 : 07/2015 If supplied, please stick your self adhesive product rating plate here, or make a note of the product serial number below in the box below for future reference. Serial Number : ................... 04308486/...
Need help?
Do you have a question about the LAM2202 and is the answer not in the manual?
Questions and answers