1. Manuals
  2. Brands
  3. General Pipe Cleaners Manuals
  4. Ultrasonic Jewelry Cleaner
  5. 88
  6. Operating instructions manual

General Pipe Cleaners 88 Operating Instructions Manual

Sectional drain cleaner for 3" through 10" lines (75mm – 250mm)
Hide thumbs
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
Model 88
™
Operating Instructions
For 3" through 10" lines
(75mm – 250mm)
Y
our Model 88 is designed to give you
years of trouble-free, profitable service.
However, no machine is better than its
operator. We therefore suggest you read
these instructions through carefully before
using your machine on the job. This will
enable you to operate the Model 88 more
efficiently and more profitably. Failure to
follow these instructions may cause
personal injury to operator or damage to
equipment.
SAVE THESE INSTRUCTIONS!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 88 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for General Pipe Cleaners 88

Summary of Contents for General Pipe Cleaners 88

  • Page 1 ™ Operating Instructions For 3" through 10" lines (75mm – 250mm) our Model 88 is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. We therefore suggest you read these instructions through carefully before using your machine on the job.

  • Page 2: Safety Instructions

    Model 88™ Safety Instructions Work Area Safety 1. Keep your work area clean and well lit. Cluttered benches and dark areas invite WARNING accidents. 2. Do not operate power tools in explosive Machine must be plugged atmospheres, such as in the presence of...

  • Page 3: Personal Safety

    Model 88™ three-pole receptacles which accept the 2. Do not force tool. Use the correct tool for tool’s plug. Use of other extension cords will your application. The correct tool will do the not ground the tool and increase the risk of job better and safer at the rate for which it is electric shock.

  • Page 4: Ground Fault Circuit Interrupter (Gfci)

    Model 88™ 2. If the power cord supplied with the machine pushed, equipment should not be used until is not long enough, be sure to use a 3-wire proper repairs can be made. heavy-duty extension cord no more than 50 4.
  • Page 5 Model 88™ Cutter Application Chart (Table 2) 5. Pull the machine back until the slack is out of the cable. With the motor switch in the Catalog # Forward position and, while standing behind “G” “L” the machine, press down on the switch Cutter Conn.

  • Page 6: Folding Handle

    GEAR REDUCER Model 88 gear reducers are filled with lubricant to Hint: It's often helpful to have a small the proper level before leaving the factory. Should...

  • Page 7: Cable Maintenance

    Motor & Gear Head Complete 88-120-1 6” Caster 88-300-2 Motor & Gear Head Complete 88-121 Caster Bolts (4) 88-301 Motor (1725 RPM) Disc. (See 88-300-1) 88-130 Front Bearing Post 88-301-1 Motor (3450 RPM) 88-130-A Bushings (2) 88-301-2 Motor (1750 RPM)

Table of Contents