Advertisement
8. Insert the long straight section of the "B" seat hanger
into the hole found at the back of the seat's right
armrest. Depress the button so that the seat hanger
will slide into the hole. Continue to insert the seat
hanger, depressing the second button, until the seat
hanger enters the hole under the front of the armrest.
The first button will come into contact with the front
hole and stop the seat hanger from moving further. You
will need to depress the first and second buttons so
that the seat hanger will continue to slide through the
front hole. The easiest way to depress the front button
is to rotate the seat hanger so that the underside of the
armrest depresses the button for you. Continue sliding
the seat hanger until the second button lines up with
the small hole at the front of the seat armrest. Rotate
the seat hanger until the button pops through this hole.
Ensure that the button fully engages the hole in front of
the armrest and the seat hanger is securely attached
to the seat.
9. Insert the long straight section of the "A" seat hanger
into the hole found at the back of the seat's left armrest
in the same manner as in step 8 above. Push the
armrest forward until it locks into place. Ensure that
the button fully engages the hole in the front of the left
armrest and the seat hanger is securely attached to
the seat.
10. Connected to the rear of the seat you will find the seat
cross brace. The seat cross brace connects to each of
the seat hangers using the plastic fitting found on the
seat hangers. Insert the seat cross brace into the "B"
seat hanger. Disregard the button for the moment. Insert
the opposite end of the seat cross brace into the "A"
seat hanger. This will require pressure to the seat
hangers to separate them enough to insert the seat
cross brace. Rotate the seat cross brace until the
buttons pop through the plastic fittings. Ensure that the
seat cross brace is securely attached to both seat
hangers.
www.childcareproducts.com.au
6
11. Slide the tray onto the end of the "B" seat
B
12. Lift the seat assembly and connect the right "B"
A
B
13. Insert the left "A" seat hanger into the motor joint
Warning: Check that both seat hangers are firmly
attached to the joint pivots and that the buttons pop
up through the holes in the pivots
14. Attach the toy bar to the front of the tray by
hanger (right side of the seat). If you look on the
underside of the tray, you will notice three ribs
with holes for the seat hanger. The first two ribs
also have slots for the button on the end of the
seat hanger to pass through. These slots will
allow the button to pass through when the tray
is held in the vertical position. Slide the tray,
holding it vertically, onto the seat hanger.
Depress the button so that it will pass through
the last rib and then release. The button will
hold the tray onto the seat hanger.
seat hanger to the swing joint pivot. You will
need to depress the button so that the seat
hanger will insert into the swing joint pivot
completely.
pivot while depressing the button.
hooking the lower hook of the toy bar under the
front lip of the tray and rotating the toy bar
toward the swing seat until the upper hook of
the toy bar hooks onto the top surface of the
tray.
www.childcareproducts.com.au
7
Advertisement
