Changing Firewall Settings - Motorola MG7550 User Manual

To configure and enable a Guest Network on the 5 GHz band, first select the
5 GHz tab, and then repeat the steps above.
Network Name can be from 6 ‐ 32 characters long. You can use the upper and lower
case letters (a – z and A – Z), numbers (0 ‐ 9) and special characters (e.g. $_/& etc.)
except the single quote ' .
Password can be from 8 ‐ 63 characters long. You can use upper and lower case letters
(a – z and A – Z), numbers (0 ‐ 9) and special characters (e.g. $_/& etc.) except the single
quote ' .

Changing Firewall Settings

A Firewall helps protect your Model MG7550 and the devices attached to it
from harm from outsiders connecting via the Internet. Model MG7550
comes with reasonable firewall settings. The firewall allows all normal traffic
to pass, but protects against well-known attacks. Normally you just leave the
firewall settings in place. If you want to change them, you go to the
Protection Firewall section of the Configuration Manager. First log into the
Configuration Manager as described in chapter 6. In summary, you type
192.168.0.1 in the address bar of your browser, go to that address, enter the
Username admin and Password motorola, then click the Login button.
This will bring you to the Basic Status and Settings page. Click the Advanced
button in the upper right. This will bring you to the Status
Hover over the Protection & Parental Control menu item, and select the
Firewall submenu.
Software page.