Adjusting Angle; Fitting The Harness - Brother BHL 3040 Operating Instructions Manual

Step 4
Loosen wing screw (1) on the coulping sleeve (2), and
pull the knob (3) and insert the driver tube (4) until the
lock button secured in place. Screw down the wing screw
(1).
3
2
1

Adjusting angle

Only adjust the cutter bar when the blades are no
longer moving and the engine is turned off.
Step 1
Push down the two adjusting lever, then pull out the safe-
ty handle along the arrow (show in the picture).
4
4
5
GB-12
Step 2
You can run the adjusting handle you need. The safety
handle will lock up automatic.

Fitting the Harness

The type and style of harness depend on the market.
• Put on the shoulder strap (1).
• Adjust the length of the strap so that the spring hook
(2) is about a hand's width below your right hip.
• Never carry the belt diagonally across your shoulders
and chest, but rather only on one shoulder, so that you
can rapidly move away from the tool in case of danger.
the Machine
Do not use your power scythe attachment during other
people's rest periods.