Fueling; Starting / Stopping The Engine - Brother BHL 3040 Operating Instructions Manual

at the pump, first remove the canister from your vehicle
and place the canister on the ground before filling. Do not
fill fuel canisters that are sitting in or on a vehicle. The
canister should be kept tightly closed in order to avoid
any moisture getting into the mixture. The machine's fuel
tank and the canister in which fuel mix is stored should be
cleaned as necessary.
Fuel mix ages
Only mix sufficient fuel for a few days work, not to exceed
3 months of storage. Store in approved fuel-canisters
only. When mixing, pour oil into the canister first, and then
add gasoline. Close the canister and shake it vigorously
by hand to ensure proper mixing of the oil with the fuel.
Gasoline
1L
5L
Dispose of empty mixing-oil canisters only at authorized
disposal locations.

Fueling

Before fueling, clean the filler cap and the area around it
to ensure that no dirt falls into the tank.
Always thoroughly shake the mixture in the canister be-
fore fueling your machine.
In order to reduce the risk of burns or other personal
injury from escaping gas vapor and fumes, remove
the fuel filler cap carefully so as to allow any pres-
sure build-up in the tank to release slowly.
After fueling, tighten fuel cap as securely as pos-
sible by hand.

Starting / Stopping the Engine

Starting
1 Put the stop switch in the position '1''1'
Oil
25ml
125ml
GB-9
2 Slide the choke to position 'start'. This is not required
in case of a warm start.
3 Push the fuel pump 6 times.
4 Push the starter rope 2-3 times, to start the motorit is
required to evenly, quickly pull the rope.
5 Slide the chock to RUN positon, slightly push the throt-
tle trigger and pull the starter rope again until the mo-
tor starts running. To push the throttle trigger(1) it is
necessary to first push the locking lever(2).
6 Let the motor idle for about 10 seconds to warm up.
7 If the motor does not start please repeat the upward-
steps.
2
1