Table of Contents
Advertisement
3
Installation
INSTALLATION
INSTRUCTIONS
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or
in direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Freezers
1" (25 mm)
3. Make sure that sufficient room is
provided around the appliance to
ensure free
air circulation. Allow a minimum of
60 mm (2.4 inches) between the top
of the appliance and the ceiling or the
underside of a wall cupboard.
4. Fit the two plastic wall spacers
supplied onto the condenser at the
back of the appliance by rotating them
1/4 turn.
5. The appliance should be located on
a smooth surface.
The two front feet can be
adjusted as required.
To ensure that,your appliance
is standing upright adjust the two
front feet by turning clockwise or
anti-clockwise, until the product is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to "Cleaning and Care"
section to prepare your appliance for
use.
7.A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage. transit
provided to avoid transit damage.
Changing the door opening
direction
Door opening direction of your
refrigerator can be changed
according to the place you are using
it. If this is necessary, please call
your nearest Authorized Service.
7
EN
Hide quick links:
Advertisement
Table of Contents
