Information On The Display Panel; Faults And What To Do About Them - Siemens WM10W460IL Instruction Manual And Installation Instructions

Information on the display panel

Display
- P - and Ï
- P -
Ï flashes
| lights up
E:18
E:23
w
o lights up
Other displays

Faults and what to do about them.

Faults
Water is leaking from the
machine.
The machine is not filling
with water.
Detergent is not being
dispensed.
The door cannot be
opened.
The programme will not
start.
Cause/Remedy
The door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the Ü button to continue the programme.
Laundry may be caught. Open and close the door again and press the Ü
■
button.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the programme and
■
make your individual settings; start the programme.
Turn on the tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 27
■
The drain pump is blocked. Clean the drain pump. ~ Page 26
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 27
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services. ~ Page 31
The childproof lock is activated – deactivate it. ~ Page 22
Too must foam has been detected and an additional rinse cycle has been activated.
Add less detergent to the next washing cycle with the same load.
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call customer services. ~ Page 31
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
Have you pressed the Ü button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter. ~ Page 27
■
Is the supply hose kinked or trapped?
■
The safety function is activated. Stop the programme? ~ Page 23
■
Is $ selected (Rinse Stop = no final spin)? ~ Page 23
■
Can the door only be opened by the emergency release? ~ Page 28
■
Have you pressed the Ü button or selected Finish in 5 time?
■
Is the door closed?
■
Is the w childproof lock activated? Deactivate it. ~ Page 22
■
Faults and what to do about them.
en
29