Noises - Electrolux ERF7000W1 User Manual

14 www.electrolux.com
4. Unscrew the lower hinge. Change
the position of the pin and buffer.
Screw the lower hinge on the
opposite side.
5. Tighten the pin with the adjustment
spanner supplied.
6. Raise the appliance and install the
ventilation grille.
7. Remove the covers on the handles
carefully with a small screwdriver.
8. Unscrew the handle.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
A1
9. On the opposite side remove the hole
covers by driving a 3-4 mm drift or
drill into them.
10. Install the handle.
11. Install the covers on the handle.
12. Install the hole covers provided within
the accessory bag.
A2
13. Put the cabinet in position.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.