Advertisement
1. If local
codes
permit
connection
of the
frame-
grounding
conductor
to the
neutral
(white
wire),
connect
the green
and white
wire from the supply
cable
of the appliance
together
and to the neutral
(white) wire in the junction
box. Connect
the remain-
ing wires from the supply
cable, matching
the colors,
to the wires in the junction
box.
2. If local codes DO NOT permit frame grounding
to the
neutral,
separate
the white
and green
wires
that
extend
out of the end of the supply
cable
of the
appliance.
Connect
the white
wire from the supply
cable to the neutral wire in the junction
box.
Connect
the black and red wire from the supply cable,
matching
the colors, to the corresponding
wires in the
junction
box. The green wire MUST now be used to
ground
the appliance
in accordance
with local electri-
cal codes.
Connect
the
green
ground
wire
to a
grounded
cold water pipe*or
to the grounded
lead in
the service panel. Do not ground to a gas supply pipe.
Do not
connect
to electrical
power
supply
until
appliance
is permanently
grounded.
Connect
the
ground
wrre before turning
on the power. See Figure
2.
CAUTION -
If connecting
to a four-wire
electrical
system
(MOBILE
HOME)
the appliance
frame
MUST
NOT be
connected
to the neutral
wire of the four-wire
electrical
system. Separate
the white and green wires that extend
out of the end of the supply
cable
of the appliance.
Connect
the white, red and black wires from the supply
cable, matching
the colors, to the corresponding
wires in
the junction
box. Connect the green wire from the supply
cable to the ground
wire in the junction
box.
COPPER
GROUND WIRE
GROUNOEO COLD
WATER PIPE
(REMOVE PAINT ETC.1
GROUND CLAMP
(MUST BE TIGHT
ON PIPEj
FIGURE 2
*Cold
water pipe must have metal continuity
to electrical
ground and not be interrupted
by plastic, rubber or other
electrically
insulating
connectors
(including
water meter
or pump) without
adding a jumper wire at these connec-
tions.
4. INSTALLATION
NOTE:
Before installing the oven in the cutout, it may be helpful to
remove the oven door. See details below.
Inset-t appliance into cut-out. Screws are provided for fasten-
ing the front frame of the appliance to the cabinet. The moun-
ting holes in the front frame of appliance
may be used as a
template to locate the appliance
mounting screw holes.
CAUTION:
For your personal
safety, and to minimize
potential
personal
injury, this oven must be securely
fastened to the cabinet,
using the four screws that are
provided.
Use caution when mounting
oven in cutout so you do
not over-tighten
screws and cause porcelain
chippage
or puncture
oven cavity.
TO REMOVE OVEN DOOR
SELF-CLEANING MODELS-
LOWER OVEN DOOR
ONLY
(Door to be removed for installation only).
1. Remove the two screws, one on each side of the inner door
panel. See View A.
SCREW
VIEW A
WARNING:
UNDER DO CIRCUMSTANCES
ARE THESE
DOOR TO BE INTERCHANGED.
3
Advertisement
