MATERIALS INCLUDED IN THIS PACKAGE: MM801 Video Monitor (P/N 136D3649) Trim Ring (P/N 102C4007) Remote Control (P/N : 136B3650) – 1pc Hardware Package:- ♦ #4 x 5/16” Screws ♦ #8 x 5/8” Self Drilling Screws ♦ #8 Washers 2 Pin Power Wire Harness with choke (P/N 112B3143) Dome light Harness (P/N 112B3110) –...
Page 4
GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, DVD, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting locations of all components and method of mounting. 4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where interconnecting wire harnesses will need to be located.
VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off). Also locate a good ground wire. Generally, these wires can be found at the ignition switch or fuse-box.
TRIM RING INSTALLATION: This page only covers special installation considerations for the trim ring installation. If the video monitor is to be installed in a vehicle with the trim ring, it may need to be trimmed to fit the contour of the vehicle headliner. In this installation, the video monitor is mounted directly to the overhead cross-member in the roof using the mounting screw bosses.
Page 7
MOUNTING THE TRIM RING Roof Roof Support Headliner 5"x9"x3/4" Plywood Block (4) #8x1" self drilling screws Trim Ring Video Unit (4) #8 flat washers (4) #8x3/4" self tapping screws...
Page 8
MM801 Red: +12VDC Accessory Ckt. (Install 5A Inline Fuse) Black: Ground IR LED: Clean the IR Receiver Window on the front of the VCP . Remove Adhesive Backing and Apply IR LED to IR Window on the Face of the VCP .
CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply volt- age to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light.
Negative Switched Dome lighting To 3 pin connector Factory Dome light circuit Troubleshooting: SYMPTOM: No power at Video Monitor Power but no video or sound Picture, but no sound Red / black - Lamp on Black / red - Lamp common Violet / brown - Lamp Auto constant Factory Door ajar...