Advertisement
Air intake
Standard connection: Air intake from installation site
Alternative connection: Ducted air intake (from outside
building)
Lid removal exposes live components! For safety
reasons, the pipe connected for central air intake should
be at least 900 mm long and secured using two screws.
Fittings
Without base
(supplied)
2 × clamps
2 × screws DIN 571 (Ø × length)
2 × rawl plugs (Ø × length)
The machine should be bolted to the floor.
Fixing materials for a floating screed floor are to be
provided on site.
On concrete platform
2 × clamps
2 × screws DIN 571 (Ø × length)
2 × rawl plugs (Ø × length)
The machine must be bolted to the floor!
Fixing materials for a floating screed floor are to be
provided on site.
Machine data
Unit width
Machine depth
Unit height
Casing width
Casing depth
Minimum width of delivery access to installation site
Recommended rear wall gap (measured to front of
machine)
Min. wall gap (to rear edge of lid)
Net weight
Max. load bearing in operation
Average heat dissipation
(dependent on ambient room temperature and program
selected)
A Noise level
A Sound pressure level
Installation should only be carried out by authorised installers in accordance with all local and national regulations!
Follow installation instructions when installing machine. All rights reserved. Measurements in millimeters [inches].
Installation plan: PT 8807 EL
Date: 2015-Sep-15
Unobstructed air intake into room recommended
(corresponding to 3 times the vent cross-section of
machine)
A sufficient supply of fresh air should be ensured to
replace the air extracted.
Connector on machine (int. diameter)
Connection pipe provided on site (ext. diameter)
cm²
531
32 cu in
6 ½"
mm
161
6 ¼"
mm
160
mm
6 × 40
mm
10 × 50
mm
6 × 40
mm
10 × 50
47 ½"
mm
1.206
54 ½"
mm
1.384
64 ½"
mm
1.640
47 ¼"
mm
1.200
50 ½"
mm
1.279
48"
mm
1.220
71"
mm
1.800
19 ¾"
mm
500
kg
287
632 lb
N
3.708
Watt
973
dB (A)
73,6
dB (A)
62
Page: 9
Advertisement
