Using Audio Features; Enjoying High Quality Sound; Adjusting The Tonal Quality; Adjusting The Speaker Level - Yamaha RX-V563 Owner's Manual

Enjoying high quality sound

Use the DIRECT mode to enjoy the high quality sounds of
the selected source. When the DIRECT mode is activated,
this unit plays back the selected source with the least
circuitry.
Press QDIRECT (or press 4AMP and then
CDIRECT) to select "
DIRECT
Notes
• "TONE CONTROL" and "SOUND MENU" (see page 59)
settings (except for speaker level settings) are not effective.
• The front panel display automatically dims.
y
While DIRECT mode is activated, the front panel display turns on
momentarily when an operation is performed.

Adjusting the tonal quality

Use this feature to adjust the balance of bass and treble for
the front left and right speaker channels.
y
Speaker and headphone adjustments are stored independently.
Press NTONE CONTROL repeatedly to
1
select the high-frequency response
(TREBLE) or the low-frequency response
(BASS).
2
Press OPROGRAM l / h repeatedly to
adjust the high-frequency response
(TREBLE) or the low-frequency response
(BASS).
Notes
• If you increase or decrease the high-frequency or the
low-frequency sound to an extreme level, the tonal quality of
the surround speakers may not match.
• TONE CONTROL is not effective when this unit is in the
DIRECT mode, or when MULTI CH is selected as the input
source.

Using audio features

You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
Note
This operation will override the level adjustments made in
"
.
"AUTO SETUP" (see page 26) and "SP LEVEL" (see page 61).
1
2
3

Adjusting the speaker level

Press 4AMP and then press 6LEVEL on
the remote control and then 7k / n to select
the speaker you want to adjust.
Display
FRONT L
Front left speaker
FRONT R
Front right speaker
CENTER
Center speaker
SWFR
Subwoofer
SUR. L
Surround left speaker
SUR. R
Surround right speaker
SB L
Surround back left speaker
SB R
Surround back right speaker
y
• Instead of "SB L" and "SB R", "SUR.B" is displayed if
"SUR.B L/R SP" is set to either "SMLx1" or "LRGx1"
(see page 60).
• The available speaker channels differ depending on the
setting of the speakers.
• When the video monitor is turned on, the "SP LEVEL"
adjustment menu appears in the video monitor.
Press 7l / h to adjust the speaker output
level.
• Press 7h to increase the value.
• Press 7l to decrease the value.
• Control range: –10 dB to +10 dB
Press 6LEVEL to turn off the speaker level
adjustment display.
USING AUDIO FEATURES
Adjusted speaker
43
En