Precautions For Installation - Panasonic WV-NP304 Installation Manual

Precautions for installation

All work related to the installation of this
product should be made by qualified serv-
ice personnel or system installers.
Use this product for indoor use only.
Do not expose this product to direct sunlight
for hours and do not install the product near
a heater or an air conditioner. Otherwise, it
may cause deterioration, discoloration and
malfunction. Keep this product away from
water.
Avoid installing in the following locations.
• Locations where it may get wet from rain
or water splash
• Locations where a chemical agent is
used such as a swimming pool
• Locations subject to steam and oil smoke
such as a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emis-
sions are produced
• Locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
between –10°C - +50°C
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as the
result of severe changes in temperature
Be sure to remove this product if it is not
in use.
Before starting installation
• Use the camera mount bracket shown on
page 23 to mount the camera.
• When installing the camera and the cam-
era mount bracket on a ceiling/wall, use
the screws listed on page 22. Screws are
not provided with this product. Prepare
them after considering the total weight,
the material and strength of the area
where the camera is to be installed.
14
• The installing place shall be sufficiently
reinforced and anchors/screws to be
used shall be strong enough for the
installation.
• Do not install the camera on a plaster
board or on a wood board since they
don't have enough strength for installa-
tion.
When tightening fixing screws
• Firmly tighten screws that are suited to fix
with the material and strength of the area
where the camera is to be installed.
• Do not use a powered screw driver.
Otherwise, it may damage the camera.
• Tighten screws firmly. After tightening
screws, check with eyes if the camera is
fixed firmly.
Safety wire
When using a locally procured safety wire to
prevent the camera from dropping, deter-
mine the installing place after considering
possibilities of injury that may be caused by
the camera mount bracket if it is damaged.
When using a safety wire, adjust the length to
stretch the wire with tension.
Adjustment of the tilting angle
Before adjusting the tilting angle of the cam-
era, make sure that the screws of the camera
mount bracket are loosened. Failure to do so
may damage both the camera and the cam-
era mount bracket. Tighten the screws firmly
after adjusting the tilting angle of the camera.
Radio disturbance
When this product is used near a TV/radio
antenna, or a strong electric field or magnetic
field (such as near a motor, a transformer or
power lines), images may be distorted and
noise may be caused.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.