Filling (Td50) - clenaware Advanced SD50 Mark 5 Owner's Manual

Filling (TD50)

 When the machine is switched on, a fill heat sequence will be performed as
follows:
 The rinse tank will fill with water.
 The drain pump will operate to vacate any water from the wash tank.
 The Fill/Ready Lamp will be illuminated orange.
 The Start Switch will be illuminated green (rotating).
 Once the rinse tank is full, the water will be heated to 82°C.
 The Fill/Ready Lamp will flash orange during heating.
 Once up to temperature, the rinse water will be pumped into the wash tank.
 After the Fill/Heat sequence has been completed, the audible alarm will bleep
five times.
 The Fill/Ready Lamp and Start switch will be illuminated green.
 "TD" will be displayed.

The rinse tank will re-fill and heat to standby temperature.
The machine will now be in
Note:
If the machine has not been switched off using the
suffered a power failure) a short refreshment cycle will be performed at start-up
to ensure that all water is vacated from the machine. The Fill/Ready Lamp being
illuminated red indicates this.
To avoid this, and to ensure hygienic conditions,
CLOSEDOWN
STANDBY
cycle at the end of a session.
www.clenaware.co.uk
MODE, ready to operate wash cycles.
CLOSEDOWN Cycle (or
ALWAYS use the