Sharp LC-37GD6U Operation Manual page 26

Watching TV
e
The words uPairing Information" may be
replaced by a different expression depending
on the manufacturer of the CableCARD.
Press ~/~ to select "Digital Setup")
JA/V
to
select "CableCARD MENU",
A/T
to select
"Pairing Information"
t
and then press
ENTER.
Digital Cable Module is called CableCARDTM. By attaching the CableCARD, you can receive various digital
services provided by your Cable Company.
To
obtain and use a CableCARD you need to first submit an
application.
Please contact your cable company to discuss receiving an application .
• When you change your adress (See page 91)
III About EAS(Emergency Alert System) (See page 91) •
t
Press MENU and the MENU screen display.
CableCARD
Sloti11~
M
DIGITAL IN
terminal
J i
i n , " '
@
If there is a white triangle at the right side of
the screen, the screen is not showing the entire
message, Press A/Von your remote control
to display the rest of the message.
@
When there is a "LINK
H
button on the screen,
there is a link to the next page. Press
ENTER
to go to the next page.
e
Turn on the
POWER.
@
Check that the CableCARD upgrade screen is
not displayed. If it is displayed, wait until it
disappears.
o
Remove the cableCARD.
A message will appear on the screen. Call
the number on the screen and tell the
operator the CableCARD 10 and Host ID
numbers displayed on the screen.
Turn on the POWER.
Connect the antenna cable to DIGITALIN.
Select HCable" from HAir/Cable" in Channel
setup mode. (See page 28)
'*
Insert the CableCARD (upper side facing left)
into the CableCARD slot
e
A message will appear on the screen. (It might
take a couple of minutes before the message
appears.) Call the number on the screen and
tel! the operator the CableCARD 10 and Host
10 numbers displayed on the screen.
~.'
~~
o
Do not insert any PCMCIA card other than CableCARD
into the CableCARD slot.
€I
Please do not pull the AC cord out while the CableCARD
is inserted.
o
After inserting the CableCARD, it may take several minutes
before video output from the selected channel appears
on screen.
•• If the above procedure does not work,
please follow the foUowing steps instead"
Disconnecting the cable antenna
G
Turn on the
POWER.
G
Check that the CableCARD upgrade screen is
not displayed. If it is displayed, wait until it
disappears.
o
Disconnect the cable antenna.
@)-25