Motorola SLVR L7 Service Manual page 28

Disassembly
28
3. Lift the camera assembly away from the transceiver PC board (see Figure 14).
Figure 14. Removing the Camera Assembly
4. Remove the rubber grommet from the camera assembly.
5. To replace, place the rubber camera assembly grommet onto the camera
assembly. Ensure the flat side of the grommet is facing away from the flex
connector.
6. Align the camera assembly to the transceiver PC board.
7. Slide the camera assembly into its slot on the transceiver PC board.Ensure
that the flat side of the camera grommet lines up with the outer edge of the PC
board.
8. Carefully press the camera flex connector into its socket on the transceiver PC
board.
9. Reassemble the transceiver PC board, transceiver PC board shield, antenna
cap, SIM, battery and battery cover as described in the procedures.
September 23, 2005
Plastic tweezers
Motorola SLVR L7
Camera assembly
050981o
6809495A77-O