Programming Sequence - Metrologic MS6720 Setting Up

Programming Sequence

Instructions
1 Scan the bar code in
2 Scan the bar codes one at a time and in the order given in the following table.
Note: When scanning the bar codes in
Scan Order
1
2
3
4
5
6
7
Each bar code has a page number in a note under it that corresponds to the hard copy page in
MLPN 2186 Metrologic
If the bar code can not be read from
Note: A PDF version of MLPN 2186 Metrologic ScanSelect
3 Exit program mode by scanning in the bar code in
4 The scanner should now be properly programmed. Repeat the
Sequence" on page 2
Note: If after following all these instructions, the scanner still does not work, it may be
MDE-4354 Setting Up Metrologic® MS6720 Bar Code Scanner • August 2005
Figure 10.
Customer Display
Manufacturer
Ultimate
IEE Technology
Figure 2 Figure 2
Figure 3 Figure 3
Figure 4 Figure 4
Figure 5 Figure 6
Figure 7 Figure 7
Figure 8 Figure 8
Figure 9 Figure 9
ScanSelect
®
available at the following URL.
ftp://ftp.metrologic.com/pub/download/productmanuals/00-02186.pdf
to ensure proper programming.
connected incorrectly or the Profit Point POS terminal may not be configured correctly.
Repeat "Setting Up the Scanner" on page
MDE-4356 Profit Point Reference Manual to determine if the Profit Point POS terminal
is configured correctly.
Figure 2 through Figure
Scanner Programming Guide included with the scanner.
®
Figure 2 through Figure
®
Figure 10.
1. See the Hardware Configuration section in
Programming Sequence
9, it may help to rotate them.
10, use the programming guide.
Scanner Programming Guide is
"Performing Verification
Page 3