Table of Contents
Advertisement
Example of connection to a computer
Computer
RGB signal conversion adapter for
Macintosh (sold separately)
To audio
output
terminal
To video
output
connector
D-SUB 15-pin
(male)
D-SUB 15-pin
(male)
RGB signal cable
(supplied as an
accessory)
NOTE:
If the mouse connector on the projector is connected to the mouse connector on the computer with the
accessory or separate mouse cable, you can then use the remote control unit in place of the computer' s mouse.
However, this function operates only when input to the RGB 1 connector has been selected. For further details,
refer to page 35.
If you wish to use the infrared mouse function, turn on the main power to the projector before turning on the
personal computer.
If using a personal computer with a suspend/resume function, the infrared mouse function may not operate until
the computer is restarted.
Refer to the data on page 19 for details of what kinds of computers can be connected to the projector. If
computers other than those listed here are used, correct operation cannot be guaranteed.
Pin configuration and signal names for RGB connector
5
10
15
NOTE:
Pin No. 12 and pin
Audio system
No. 15 on 15-pin
connectors will
only work if the
computer supports
them.
13-pin (male)
Mouse cable for PS/2
(supplied as an accessory)
To mouse connector
To audio output terminal
-34-
Pin No.
1
1
2
6
3
11
9
12
13
14
15
4-8,10, and 11
Computer for
control use
D-SUB 9-pin
(female)
Computer
To video output connector
Signal name
R
G/G.SYNC
B
NC
SDA
HD/SYNC
VD
SCL
GND
Advertisement
Table of Contents
