Table of Contents
Advertisement
<Switching the signal mode during RGB signal input>
If the picture is not projected normally when the selected input source is "RGB 1" or "RGB 2" because the signal
mode selected does not match, select the correct signal mode by the procedure given below. The factory pre-
setting is "AUTO" , so the projector can usually be used without the need to change this setting.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the " " and " " buttons to select " PICTURE" .
3. Press the " <" and ">" buttons to display the PICTURE screen
4. Press the " "and " " buttons to select " SIGNAL MODE" .
5. Press the " <" and ">" buttons to switch the signal name.
Refer to the table below when switching to the matching signal mode.
Display mode name
Automatically switches to whichever of the following signal modes best matches the input signal,
AUTO
VGA 400
VGA 480
MAC 13
PC 98
VESA
S-VGA 1
S-VGA 2
S-VGA 3
S-VGA 4
S-VGA 5
MAC 16
XGA 1
XGA 2
XGA 3
MAC 19
NOTE:
The display resolution for the PT-L592U projector is 800 X 600 dots. If any of the above signals which have
resolutions greater than this are input, the resolution will be converted to 800 X 600 dots.
The setting screen and the MENU screen can both be cleared by pressing the MENU button.
Horizontal scanning frequency (kHz)
No. of dots
640 X 400
640 X 480
640 X 480
640 X 400
640 X 480
800 X 600
800 X 600
800 X 600
800 X 600
800 X 600
832 X 624
1024 X 768
1024 X 768
1024 X 768
1024 X 768
Signal data
Vertical scanning frequency (Hz)
31.5
31.5
35.0
24.8
37.9
35.2
37.9
46.9
48.1
32.1
49.7
48.4
56.4
68.7
60.2
-19-
70.0
60.0
66.7
56.4
72.8
56.3
60.4
75.0
72.0
51.0
74.6
60.0
70.0
85.0
75.0
Advertisement
Table of Contents
