4.1.3 Check the equipment powered by this engine
Review the instructions provided with the equipment powered by this engine for any precautions and procedures that should be
followed before engine startup.
4.2 Operation
Safe operating precautions
Safety operating the engine for the first time, please review the important safety information and the chapter titled before operation.
Carbon monoxide gas is toxic. Breathing it can cause unconsciousness and even kill you. Avoid any areas or actions that expose you to
carbon monoxide.
Review the instructions provided with the equipment powered by this engine for any safety precautions that should be observed in
conjunction with engine startup, shutdown, or operation.
4.2.1 Starting the engine
•
Open fuel valve – position
•
Turn the engine switch to tte
•
Operate starter. Pull the starter grip lightly until you feel resistance, then pull briskly. Return the starter grip gently.
4.2.2 Stopping the engine
To stop the engine in an emergency, simply turn the engine switch to the OFF position, under normal conditions, use the following
procedure.
•
Turn the engine switch to the
•
Turn the fuel switch to the
4.2.3 Setting engine speed
Position the throttle lever for the desired engine speed Some engine applications use a remotely-mounted throttle control rather than
the engine-mounted throttle lever shown here. For engine speed recommendations, refer to the instructions provided with the equipment
powered this engine.
5 Servicing your engine
5.1 The importance maintenance
Good maintenance is essential for safe, economical, and trouble-free operation, it will also help reduce air pollution.
Improperly maintaining this engine, or failure to correct a problem before operation, can cause a malfunction in which you can be
seriously hurt or killed. Always follow the inspection and maintenance recommendations and schedules in this owner's manual.
ON
- see to chapter 3.1.1
ON
position – see to chapter 3.1.3.
OFF
position - see chapter 3.1.3.
OFF
position- see chapter 3.1.1
VARI XP-200
When adjusting the throttle in a state that
shows an image step must be steel drawer
slides greater than 38 mm.
9
Need help?
Do you have a question about the xp-200 and is the answer not in the manual?
Questions and answers