Specifications Of The Engine; Operation; Before Operation; Check The General Condition Of The Engine - Vari xp-200 User Manual

3.4 Specifications of the engine

Description
Engine type
Bore x Stroke
Displacement
Zapalovací systém
Ignition system
Maximum Outout power/Speed
Maximum Torque/Speed
Idle speed
Valve lash Intake
Exhaust
Specific fuel consumption
Lube consupmtion
Noise
Net weight
Dimensions (L x W x H) – excluding the crankshaft
output
Tab. 2: Engine specification

4 Operation

4.1 Before operation

Is your engine ready to go?
For your safety, and to maximize the service life of your equipment, it is very important to take a few moments before you operate the
engine to check its condition, be sure to take care of any problem you find, or have your serving dealer correct it, before you operate the
engine.
Improperly maintaining this engine, or failing to correct a problem before operation, could cause a malfunction in which you could be
seriously injured.
Always perform a preoperation inspection before each operation, and correct any problem.
Before beginning your preoperation checks, be sure the engine is level and the engine switch is in the OFF position.

4.1.1 Check the general condition of the engine

•
Look around and underneath the engine for signs of oil or gasoline leaks.
•
Remove any excessive dirt or debris, especially around the muffler and recoil starter
•
Look for signs of damage..
•
Check that all shields and covers are in place, and all nuts, bolts,
•
and screws are tightened.

4.1.2 Check the engine

•
Check the engine oil level, running the engine with a low oil level can cause engine damage.
•
Check the air filter, A dirty air filter will restrict air flow to the carburetor, reducing engine performance.
•
Check the fuel level, starting with a full tank will help to eliminate or reduce operating interruptions for refueling.
8
Unit
-
mm
cm 3
-
-
kW/min -1
Nm/min -1
min -1
mm
g/kW.h
g/kW.h
Standart
Sound pressure level dB(A)
Sound power level dB(A)
kg
mm
VARI XP-200
Value
XP200 (1P70F/P-H)
70 x 51
196
Tranzistor magneto
Recoil starter
3,6/3800
10/3000
1520±152
0,10-0,15
0,15-0,20
≤ 395
≤ 6,8
The Noise level was tested according to
EN 1679-1, EN ISO 3744
76
97
14
415x340x270