Installing The New Machine - Fetco PEL0101 User Manual

During maintenance and cleaning, or in case of
bad functioning, disconnect the machine from the
power plug (by pulling the plug and not the
cable) (pic. 2 and 3).
Only specialized and authorized staff can repair
the machine. Not perfect repairing can be
dangerous for the user. contact Fetco for
information concerning the closest authorized
service center.
For safe operation the maximum tilt of the appliance is 1,5 degree towards the front side (outlet).
The appliance is not suitable for installation in an area where a water jet could be used.
The appliance is only to be installed in locations where its use and maintenance is restricted to trained
personnel.
This machine for the production of cold drink, slush, and sherbets grants the absolute homogeneity of
the product and the possibility to regulate its density thanks to an innovative electronic control. Before
installing the machine, verify that:
 First Class is not placed by an heat source;
 The machine has not been damaged during transportation. In case of doubt, contact the
supplier;
 The power supply system is endowed with a grounding that respects the rules of law;
 The power supply system capacity is adequate to the maximum power of the machine, as
indicated on the plate (pic. 4 pag.18).
In case of doubt, contact only qualified staff.
In order to install the machine, carefully read the following instructions.
This machine is only for the use it has been manufactured for. Any other usage is to be considered as
improper and dangerous.
It is suggested that the machine is installed only by qualified staff. A wrong installation can cause
damage to people or things, for which things the manufacturer declines any responsibility.
Once the machine is unpacked, verify the integrity of the machine. The packaging elements (plastic
bags, expanded polystyrene, nails, etc.) must not be left at children reach as they might be
dangerous. Remove the protection plastic stripes also from the internal side of the grids.
Do not connect the machine through adaptors, multiple plugs and/or extension cords. If necessary,
use only materials that conform to the safety rules in force, as for the current intensity up to what
indicated on the serial data plate.
Place the machine so as to avoid any heat source to be close to the grids. Verify that there is a free
space of 9 inches at least around the machine (pic. 5 in appendix-88). After connecting the machine
to the power supply and switching on the main switch, verify that air comes out from the side grids
(pic. 6 in appendix-88).

Installing the new machine

Warnings
Installation