Connecting Through The Access Point - Panasonic PT PT-LB90NT Network Operation Manual

Connecting with wireless LAN

Connecting through the access point

You can make the setting for infrastructure mode
administrator on network settings before changing any settings.
※"Glossary" (See pages 70 - 71)
A Projector settings
1
Turn on the projector and press the [NETWORK] button on the remote control.
2
Press the menu button to open the [NETWORK] menu, and then select from among
[USER 1] through [USER 3] for [WIRELESS LAN] and press [ENTER].
3
Set the details of network and select [OK].
As for network setting items, see pages 53 - 55.
Confirm to your system administrator on network settings before changing any settings.
The projector's MAC address
("Verifying settings"→ See page 59) ※"Glossary" (See page 70)
B Computer settings
4
Turn on the computer.
5
Make the network setting according to your system administrator.
6
Connect to your access point.
7
Start Wireless Manager ME 5.5.
A confirmation message appears asking whether to switch the projector to the network or not. Select [No].
8
Select a projector you want to connect on the <Projector Search> window ([S-MAP]
or [1-4/U]), and click [Connect]. (See pages 18, 19)
The launcher appears and the connection with the projector is established.
("Description of the launcher" → See page 32)
If no projector is displayed, click [
If you cannot establish wireless LAN connection via an access point after performed the right steps described in "A Setting
projector", contact the manufacturer of your access point (i.e. radio relay device).
(cont.)
(connection through the access point
※
can be checked with [STATUS] in the network menu of the projector unit.
※
] to start searching by IP address. (See page 29)
24
); however, confirm to your system
※