Toyota 2002 Corolla Owner's Manual page 186

1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see "TUNE" button).
Push and hold down the button until you
hear a beep—this will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
AM·FM
Push "AM·FM" to switch between the AM
and FM bands. "AM" or "FM" will appear
on the display.
If the audio system is off, you can turn
on the radio by pushing "AM·FM".
112
'02 Corolla U (L/O 0105)
BAL (Balance)
Turn the "BAL" knob with pulling to adjust
the balance between the right and left
speakers.
PWR·VOL (Power·Volume)
Push "PWR·VOL" to turn the audio system
on and off. Turn "PWR·VOL" to adjust the
volume.
ST (Stereo reception) display
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. "ST" appears on the display. If the
signal becomes weak, the radio reduces
the amount of channel separation to prev-
ent the weak signal from creating noise.
If the signal becomes extremely weak, the
radio switches from stereo to mono recep-
tion.
TONE
Move the "TONE" ring around "BAL" to
adjust the tone.
2002 Corolla_U (OM12743U)
TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR). Push and release the " " (up) or
" " (down) side of "TUNE" to step up or
down the station band. (If you hear a
beep, you held the button too long and
the radio will go into the seek mode.)
Seeking
In the seek mode, the radio finds and
plays the next station up or down the
station band.
To seek a station, push and hold the " "
or " " side of "TUNE" until you hear a
beep. Do this again to find another sta-
tion.