Rear Wheel - Yamaha 2010 XV250Z Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Remove the axle nut cotter pin.
2. Loosen the chain puller locknut
and the drive chain slack adjusting
nut on both ends of the swingarm.
1. Axle nut
2. Axle nut cotter pin
3. Chain puller locknut
4. Drive chain slack adjusting nut
5. Alignment marks
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU25080 3. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
EAU32751
4. Lift the rear wheel off the ground
according to the procedure on
EWA10821
page 7-33.
5. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
shaft lever.
6. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
1. Brake torque rod
2. Brake torque rod bolt and nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
7. Push the wheel forward, and then
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
8. Remove the axle nut.
9. Pull the wheel axle out, and then
To install the rear wheel
1. Install the drive chain onto the rear
2. Install the brake rod onto the brake
3. Connect the brake torque rod to
4. Install the axle nut.
5. Lower the rear wheel so that it is
7-36
remove the drive chain from the
rear sprocket.
remove the wheel.
sprocket, and then install the
wheel by inserting the wheel axle
from the right-hand side.
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
the brake shoe plate by installing
the bolt and nut.
on the ground, and then put the
sidestand down.
EAU32764
7