Toyota 2005 Prius Owner's Manual page 196

(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
196
R
CAUTION
D
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
R
rage door or other device to pre-
vent potential harm or damage.
D
Do not use this HomeLink
sal Transceiver with
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with Part 15 of the
FCC Rules and with RSS−210 of the IC
Rules. Operation is subject to the fol-
R
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received,
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and IC
R
Univer-
Rules. Changes or modifications not
any garage
expressly approved by the party re-
sponsible for compliance could void
the user's authority to operate the
device.
garage door
including interference