Honda 1996 Accord Coupe Owner's Manual page 84

Audio System
Operating the Radio
The ignition switch must be in AC-
CESSORY (I) or ON (II). Turn the
system on and adjust the volume by
turning the ON/OFF/VOL knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the A M / F M
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
You can use any of three methods to
find radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
Comfort and Convenience Features
TUNE — Use the TUNE/SEEK
switch to tune the radio to a desired
frequency. Push the switch up to
tune to a higher frequency, and push
the switch down to tune to a lower
frequency. The frequency numbers
will start to change rapidly. Release
the switch when the display reaches
the desired frequency. To change
the frequency in small increments,
push and release the TUNE/SEEK
switch quickly.
SEEK — The SEEK function
searches the band for a station with
a strong signal. To activate it, push
the TUNE/SEEK switch until you
hear a beep, then release it.
Depending on which way you pushed
the switch, the system scans upward
or downward from the current
frequency. It stops when it finds a
station with a strong signal.
Preset — You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency
on the AM band, and two on the FM
band.