Carton Contents And Item Checklist - Rinnai Energysavers RHFE-1005FT Operation And Installation Manual

Carton contents and item checklist

Unpacking the appliance
The heater is supplied in one carton containing the heater, standard rear panel set and screw pack.
Remove all packaging materials and check for damage. If any damage is evident do not install or operate
the appliance—contact your place of purchase for advice.
Before installing the heater, check it is labelled for the correct gas type. Refer to the data label at the rear
of the heater.
The heater does not come supplied with flue components. These are purchased separately. Only Rinnai
Energysaver flue components can be used with this appliance.
Carton contents and item checklist
Check you have:
• One of the following Rinnai Energysaver heaters
- RHFE-309FT
- RHFE-561FT
• One rear panel set comprising of left, right, and top panel cover panels
• One pack containing the following
Part
Plastic inlet hose clips (holds the air intake
hose in place)
Air intake baffle ring* (ensures maximum
efficiency of the heater p. 21)
Stainless steel sheath clamp (holds the
protective sock on the exhaust pipe in place)
Securing brackets (secures the heater to the
wall p. 21)
150 mm cable tie (secures the air inlet elbow
onto the flue)
Flue lock clamp (secures the exhaust pipe
assembly onto the flue)
Screw hardware pack
* The air intake baffle ring is only required to be installed on 309FT/559FT models using the ESDFK component
in a direct flue installation.
Plastic inlet hose clip
- RHFE-559FT
- RHFE-1005FT
Stainless sheath
RHFE-1005FT RHFE-309FT/559FT/561FT
0 2
0 1 (309FT/559FT models only)
1 1
2 2
1 1
1 (large) 1 (small)
1 (small)
1 1
Cable tie
Energysaver operation and installation guide 02-15 | 15
Flue lock clamp