Handlebar Switches - Yamaha 2001 YZF-R1M Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Use the chart below to identify the
faulty electrical circuit.
CB-26E
Specific r/min Faulty electrical circuit
3,000 r/min Throttle position sensor
4,000 r/min Speed sensor
7,000 r/min EXUP system
3 If the tachometer displays such an er-
ror code, note the circuit-specific num-
ber of r/min, and then have a Yamaha
dealer check the motorcycle.
CAUTION:
@
When the tachometer displays an
error code, the motorcycle should
be checked as soon as possible in
order to avoid engine damage.
@
This model is also equipped with a self-
diagnosis device for the fuel level warn-
ing light circuit. If the fuel level warning
light circuit is defective, the following
cycle will be repeated until the malfunc-
tion is corrected: The warning light will
flash eight times, then go off for three
seconds. If this occurs, have a Yamaha
dealer check the motorcycle.
EC000004
1. Pass switch "PASS"
2. Dimmer switch
3. Turn signal switch
4. Horn switch "

Handlebar switches

Pass switch "PASS"
Press this switch to flash the headlight.
Dimmer switch
Set this switch to "
beam and to "
3-7
"
EAU00118
EAU00120
EAU00121
" for the high
" for the low beam.