Tv Operation - Integra DHC-80.6 Advanced Manual

3. With the number buttons, enter the 5-digit remote control
code within 30 seconds.
r The registration is complete when the Remote Mode
button flashes twice. The Remote Mode button
flashes once slowly when registering the remote
control code fails. Try the registration again.
„ Remapping the Colored Buttons
The colored button assignment on the AV receiver's remote
controller can be remapped to match that on the remote
controller of the component whose remote control code
you programmed to Remote Mode. However, you will not
be able to remap the colored buttons if Zone 2/Zone 3 is
selected.
1.
Hold down the Remote Mode button to map and A (Red)
simultaneously until the Remote Mode button lights
(about 3 seconds).
r Remapping is possible only for codes included in the
categories of the Remote Control Code List (such as
DVD player and TV).
2.
Within 30 seconds, press the colored buttons from left to
right, in the order you want to remap.
r For example, if the colored buttons on the remote
controller of the other component are yellow, green,
blue, and red from left to right, press the buttons on
the AV receiver's remote controller in that order.
r The registration is complete when the Remote Mode
button flashes twice. The Remote Mode button
flashes once slowly when registering the remote
control code fails. Try the registration again.
r Pressing any other button than a colored button
cancels the remap operation.
„ Resetting the Remote Mode Buttons
You can reset the remote control code registered in the
Remote Mode button to its default status. This operation
can be executed on a single Remote Mode button.
1.
Press Home for 3 or more seconds while holding down
the Remote Mode button you want to reset.
r The Remote Mode button stays lit.
2. Within 30 seconds, press the Remote Mode button
again.
r Resetting is complete when the Remote Mode
button flashes twice.
To reset all the remote controller settings: While holding
down Receiver, press and hold down Home until the
Receiver button lights (about 3 seconds). Press Receiver
again within 30 seconds. Reset is complete when the
Receiver button flashes twice.
Operating Other Components with the Remote Controller

TV Operation

Press the Remote Mode button programmed with the
remote control code for the relevant AV component to
switch the remote controller mode to that for the AV
component. Then, operate by using the corresponding
buttons. Available buttons vary depending on the product
category of the component. Operation may be incorrect or
impossible depending on the product.
1
2
1
Remote Mode
2
, Input, VOL /
3
Muting
4
CH +/-
5
6
7
5
Guide
6
/ / / , Enter
7
Setup
8
PREV CH
9
Return
3
4
8
9
57