Advertisement
TM
TPX24BIDBB—GE Profile
Collar Trim Installation
1/2" minimum
70-1/4"*
24-1/2"*
36-1/8"
*The rough-in dimension of 70-1/4" is minimum and is measured from the
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening to allow additional clearance between cabinet doors and
top of refrigerator trim when cabinet doors are in open position.
Water
Electrical
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
25"
Cabinet
Counter
Top
Trim
Specification Revised 5/00
23.5 Cu. Ft. CustomStyle
™
Refrigerator
Case
Magnetic
Tape
Door Gasket
Side trim must be installed
flush with the gasket contact
surface on the case.
Side-by-Side Refrigerator
™
Overhead
3/4" Cabinet
Cabinet
Side Panel
1/2" Cabinet
Side Panel
Case
Side Trim
Typical Installation
Shaded areas represent front surfaces
of side panels and overhead cabinet or
soffit that contacts trim.
Collar Trim Installation
Cabinet
An enclosure is required to match up to the
Door
trim, see Typical Installation. To obtain the most
integrated look, the cabinet or soffit above the
1"
refrigerator should extend out to the same
depth as the side panels. The refrigerator
opening must have minimum dimensions of
70-1/4" high x 36-1/8" wide x 24-1/2"* deep as
shown at right. If there is an overhead cabinet,
Top
allow 1" for cabinet door clearance with the top
Trim
trim piece so the cabinet doors can be opened
without hitting the top trim. If 1/2" side panels
are used, then side trim and panel will be even.
If 3/4" side panels are used, then some of the
side panel will extend beyond the trim and
must be finished.
*24-1/2" Depth applies to the refrigerator
opening, not the actual cabinet depth.
IMPORTANT: Before finalizing for your
GE Profile Performance
CustomStyle
Refrigerator, please NOTE:
™
• A minimum of 36-1/8" is required for
Refrigerator installation.
• Be sure to allow for 1/2" or 3/4" side panels in
addition to the 36-1/8" minimum.
™
and GE Profile
™
Advertisement
