Samsung RS26TKA User Manual page 18

setting up your side-by-side refrigerator
CHECKING THE WATER DISPENSER LINE
A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote
better health, the Samsung water filter removes unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to
do that.
In order for the ice maker to operate properly, a water pressure of138~862 Kpa is required.
Under normal conditions, a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with low water pressure (below 138Kpa), you can install a
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water line installation kits are include with unit. You can find it in freezer drawer.
INSTALLING THE WATER DISPENSER LINE
Parts for water line Installation
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in the installation kit.
Close Main
Water pipe
4. After connecting the water supply to the water filter, turn your main water supply back on and
dispense about 3L to clear and prime the water filter.
The water line must be connected to the cold water pipe. If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
CAUTION
18_setting up
1 Water line fixer
and screws
2 Pipe connector 3 Water line
Close Main NO GAP
Water pipe