Stanley SIG 2500 Original Instructions Manual page 12

G
B
If the engine is low on oil while it is running, the oil
•
warning indicator (Item 15) will light up red and the
engine will stall. The oil indicator goes out when the
engine has come to a complete stop.
The engine oil must be topped up before the engine can
•
be started again.
9.4 Air filter (Figs. 9, 10)
Clean the air filter at regular intervals, and replace it if
necessary. Please also read the service information.
Remove the air filter cover (Item E).
•
Remove the air filter (Item G).
•
Clean the air filter by tapping it. In cases of stubborn
•
dirt first clean with soapy water, then rinse with clear
water and air-dry before reinserting. Important: Do not
use abrasive cleaners or petrol to clean the air filter.
Assemble in reverse order.
•
9.5 Spark plug (Fig. 11)
Check the spark plug for wear at regular intervals. Please
also read the service information.
Pull off the spark plug boot (Item I) by twisting it.
•
Remove the spark plug (Item J) using the supplied spark
•
plug wrench.
Clean the spark plug with a copper wire brush or fit a
•
new one.
Assemble in reverse order.
•
12