Table of Contents
Advertisement
Self-adjusting Mode
After installing the water heater you must proceed to Self-
adjusting Mode before using the water heater.
Caution
In Self-adjusting Mode, the water heater calculates the load according to the
installation circumstances (altitude, vent) and self adjust the heat capacity
by itself.
To use the Self-adjusting Mode:
1
Connect the power supply.
2
Press the
button.
3
Open more than two faucets and dispense approximately 4
gallons (15 liters) of water.
4
Check that the
icon is turned on.
Notice
Temperature is set to 120°F (50°C) by default.
32
Installation Manual
5
Touch the
button and increase the temperature higher
than 160°F (71°C).
6
Touch the
button and turn off the water heater.
Hide quick links:
Advertisement
Table of Contents
