Sanyo DC-MP9500 Instruction Manual page 4

L ch speaker
Video/Auxiliary equipment
Note:
- Do not connect the mains lead to an AC outlet until all connections
have been made.
- The system is not completely disconnected from the mains when the
z/ON button is set to the z position.
Speakers
Connect the connector of the left speaker lead to the "L" SPEAKERS
socket and the connector of the right speaker lead to the "R" socket.
If you have difficulty inserting the speaker lead connector, turn it over and
reinsert it.
When connecting the speakers, make sure that + and - polarities are
matched properly. Otherwise, the sound may appear to be lacking in the
bass range and stability.
Connect the red speaker wire to the red terminal + and the black wire to
the black terminal -.
FM Aerial
FM indoor aerial is sufficient to receive broadcasts. Extend the aerial wire
as straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
AM Loop Aerial
Assemble the loop aerial as shown in figure.
CONNECTIONS
R ch speaker
+
LEFT
+
RIGHT
+
LEFT
PHONES
RIGHT
+
SPEAKE
(6Ω M
L NE IN
R
L
RESET
To an AC outlet
Unwind the aerial wires, then connect them
to the AM LOOP terminals. Place the loop
aerial in a position which yields the best AM
reception, or attach it to a wall or other sur-
face as shown in figure.
Note:
To minimize noise, the speaker, mains and
any other leads should not come close to
the indoor or external aerial lead and AM loop
aerial. Do not place the aerial leads close to
the system.
Headphones
Connect stereo headphones (not supplied) to the PHONES socket (rear
of the unit) for monitoring or for private listening. The speakers are auto-
matically disconnected when headphones are connected.
Video/Auxillary equipment
Connect audio leads (not supplied) from the audio output socket of a video/
auxilary equipment to the LINE IN sockets.
-2-
FM Aerial
AM loop Aerial
AM
LOOP
FM
ANT
Screws (not supplied)