Quick Set Control - Hotpoint RE968 How To Get The Best

How R)
use
QUICK SET control
The QUICK SET Control provides a
short-cut method for entering time
and the Power Level on your micro-
wave oven. QUICK SET Codes are
only used for recipes which need
little or no attention, and which
require no change of power level
during cooking. Recipes which
require additional ingredients,
attention or change of power level
during microwaving should be
cooked in the usual manner. Also,
recipes with cooking time of less
than one minute or more than 99
minutes can not use Codes.
Tounderstand the QUICK SET
Code control, it is important to know
what the numbers mean and what
the sequence is. The first and sec-
ond numbers, if setting a 3 digit
Code, indicate the amount of time
you desire; the last control entry
QUICK SET
2-Digit
R'
50
Time in Power Level
Minutes High (10)
number is always the Power Level.
For example, 125 means 12 minutes
at Power Level 5. NOTE: Your oven
can only be programmed to 99 min-
utes when using the QUICK SET
control and the highest Power Level
is 10 which is represented by "O".
When setting a 2 digit QUICK SET
control entry, the first is time, the sec-
ond is power level. For example, 50
means 5 minutes at Power Level 10.
On the following page is shown
many frequently prepared foods and
their codes. It's easy, though, to
make Codes for many other recipes.
Just select one or two digits repre-
senting the length of cooking time
desired, and a final digit for the
Power.Level required. The Codes
given on the chart are for the min-
imum time needed, to avoid over-
cooking which can dry out food and
Hclw
to
set
QUICK SE-r Ckmwd
Programming your oven for QUICK
SET Control operation is easy.
Follow these simple steps.
Step 1: Touch QUICK SET. ENTER
CODE flashes.
For
Example:
.
Step 2: Enter the proper code. For
example, a recipe calling for 12
minutes cooking time at Power
Level 10 would be 120.120 appears
on the display panel.
make it tasteless and tough. If you
feel that more cooking is needed,
add additional time by changing the
*
first digit of the Code. You cannot
add seconds to the cycle time—
0
Codes are for whole minutes only.
If your recipe calls for Power Level
changes or different amounts of
time needed between addition of
ingredients, you may set one Code
for the first part of the recipe, then
after completion, set another Code
for that period of time and Power
Level.
Remember that QUICK SET Codes
are for microwaving by time only. If
you are microwaving by tempera-
ture, you must use the Temp Cook
or Auto Roast function.
When the oven completes QUICK
SET program, it automatically shuts
off. It will then display "End" and
beep once a minute until you either
open the door or touch the CLEAR/
OFF pad.
QUICK SET
3-Digit
R
Time in
Power Level
Minutes
Med (5)
t
12